• Registered: 2008-11-01
  • Posts: 3

Topic: Integrate drivers to boot.wim in a Windows 7 x86/x64 AIO

Is it possible to integrate mass storage and chipset drivers to boot.wim in an already done Windows 7 AIO that has both x86 and x64 architectures?

  • Registered: 2012-09-13
  • Posts: 170

Re: Integrate drivers to boot.wim in a Windows 7 x86/x64 AIO

I'm not sure, I think you would run into driver conflicts.

  • From: Cambridgeshire, UK
  • Registered: 2007-01-27
  • Posts: 6,226

Re: Integrate drivers to boot.wim in a Windows 7 x86/x64 AIO

DISM is very resilient when it comes to drivers.
Try it, the worst you could do is waste your time.

Read BEFORE you post.  HWID tool   DriverPacks Tutorial   DONATE!
http://driverpacks.net/userbar/admin-1.png
Not all heroes wear capes, some wear Kevlar!
  • Registered: 2008-11-01
  • Posts: 3

Re: Integrate drivers to boot.wim in a Windows 7 x86/x64 AIO

So I could infer from your comments is better to inject drivers in both architectures separately and make the AIO at the end, right?

Last edited by diabolo131313 (2013-01-05 13:07:33)

  • OverFlow
  • DriverPacks Administrator & BASE Developer
  • Offline
  • From: Cincinnati
  • Registered: 2006-12-02
  • Posts: 6,730

Re: Integrate drivers to boot.wim in a Windows 7 x86/x64 AIO

it is possible to remove the existing drivers (non native drivers previously added by dism)

you could then add all new drivers... and have no conflicts.

it is also possible to pick and choose ... but this sounds tedious.

check the docs tab on the / our home page... i posted some notes a while back that help with adding / deleting drivers

DP BartPE Tutorial   DP_BASE Tutorial   HWID's Tool     Read BEFORE you post    UserBars!
http://driverpacks.net/userbar/admin-1.png
The DriverPacks, the DP_Base program, and Support Forum are FREE!.

OverFlow's Website

  • Registered: 2008-11-01
  • Posts: 3

Re: Integrate drivers to boot.wim in a Windows 7 x86/x64 AIO

Thanks all you guys for your guidance