• Registered: 2010-07-13
  • Posts: 2

Topic: Setup cannot copy * after MassStorage driver update

Hello,
Just as the title sais, I tried a second time integrating the newest version of mass storage drivers with the newest Base and I get two errors in text mode when the files are copying:

- Setup cannot copy sr.inf
- Setup cannot copy sr.mof
+ It doesn't correctly install settings and files...

I integrated them over the 9.01 version (dunno if it deletes previous versions) and with that it wasn't displaying any errors.
Is there any way I can correct that?

Thanks in advance.

Last edited by LeppeRMessiaH (2010-07-13 21:09:55)

  • OverFlow
  • DriverPacks Administrator & BASE Developer
  • Offline
  • From: Cincinnati
  • Registered: 2006-12-02
  • Posts: 6,730

Re: Setup cannot copy * after MassStorage driver update

you can NOT make changes to your source after you run DriverPacks BASE on it...

if DriverPacks was not the last step in your process before creating the ISO / Disc then you can NOT update the mass storage drivers.

It sounds like you made changes after you added the DriverPacks... If that is so then you must start over with a clean source.

this is stated in the tutorial big_smile.

DP BartPE Tutorial   DP_BASE Tutorial   HWID's Tool     Read BEFORE you post    UserBars!
http://driverpacks.net/userbar/admin-1.png
The DriverPacks, the DP_Base program, and Support Forum are FREE!.

OverFlow's Website

  • Registered: 2010-07-13
  • Posts: 2

Re: Setup cannot copy * after MassStorage driver update

Thanks for your reply. I will try.