Topic: Help with AMD RAID 0 txt setup configuration for DPBase intergration.
If this is in the wrong place my apologizes, or has already been posted of the sort
I've been using the driver packs for sometime now and not a glitch while using them 
and I have created my own driver packs for my "older" system. However I'm in a fix with my new system TA790GX128M AMD based board, I have the drivers for the txt setup on RAID 0 etc for x86 and x64 that fits on floppy. I'm tired of relying on that drive for installation, as they are good for paper weights now, seems I have a few other files in my driver package that I really don't know what to do with 
, screens below,
My question is - For these drivers to be recognized at setup, so I can continue without the F6 stroke, what part of these would I need??
and in what fashion would I organize them to work??
I have used Driver Guinness Pro to grab all my other NON Windows drivers for this board, and to my surprise it grabbed the AHCI drivers witch I thought were what I need to install in RAID 0 but they are not, I was confused for a bit till I looked at the PCI VEN code from system hardware info. to drivers that was grabbed with DGPro etc..
Floppy disk drivers for the RAID..
this is just the first part of the txtsetup.oem file in the second shoot above the rest is PCI\VEN code
[Disks]
disk0 = "AMD AHCI Compatible RAID Controller Driver Diskette", \ahcix86, \
disk1 = "AMD AHCI Compatible RAID Controller Driver Diskette", \ahcix86, \x86
disk2 = "AMD AHCI Compatible RAID Controller Driver Diskette", \ahcix64, \x64
[Defaults]
SCSI = Napa_i386_ahci8086
[SCSI]
Napa_i386_ahci8086 = "AMD AHCI Compatible RAID Controller-x86 platform", ahcix86
Napa_amd64_ahci = "AMD AHCI Compatible RAID Controller-x64 platform", ahcix64
[Files.SCSI.Napa_i386_ahci8086]
inf = disk1, ahcix86.inf
driver = disk1, ahcix86.sys, ahcix86
catalog = disk1, ahcix86.cat
[Files.SCSI.Napa_amd64_ahci]
inf = disk2, ahcix64.inf
driver = disk2, ahcix64.sys, ahcix64
catalog = disk2, ahcix64.catOPPS forgot to say this is for 32 bit for xp and x64 for Xp on seperate builds..
Any help on this would be of Great Appreciation, and would be nice to add to the MassStorage or a new driver pack for SATA RAID only maybe - I dont know lol
Thanks for Your time on this
EDIT:..As I look through the MassStorage pack I do see the IDE and SATA drivers also the RAID for 6xx and 7xx in AM2 folder,,SO I guess at this point the question would be - where/what would I need to edit to add the txt setup.oem file to be read during setup as the rest looks like just relative editing the main .ini and adding the corresponding folder with proper lable to said edited .ini area?? correct
Last edited by emplosion69 (2009-07-08 23:54:33)
