• Zacam
  • DriverPacks newbie
  • Offline
  • Registered: 2007-09-17
  • Posts: 1

Topic: Question regarding DOSNET.INF

So, I optimized the DOSNET.INF file by alpabetizing the [Files] section according to a DOS dir cmd.

Worked very nicely.

Curious though if anyone has tried removing the [FloppyFiles.#] sections or if they are still needed by setup? And if they are still needed, will it work to combine them into a single FloppyFiles section?

In short, I'm trying to optimize as much as possible. Managing to remove a large amount of redundant copies of entries in the [Files] section and what not helped a great deal, looking to see how far it can be taken.

If nobody has any idea, then I'll go ahead and test it anyway.

Last edited by Zacam (2007-09-17 13:00:50)

  • Jaak
  • Old Timer Rookie
  • Offline
  • From: Eeklo, in the East Flanders
  • Registered: 2006-07-23
  • Posts: 3,594

Re: Question regarding DOSNET.INF

hi

when you do this, I wish you good luck, because we have set some drivers to load AFTER another because of reported conflicts if they was loaded in front of particular ones.

The answer was 42?
Kind regards, Jaak.