DriverPacks.net Forum - [NEEDS REPLY] Fatal error during gui setup

Re: [NEEDS REPLY] Fatal error during gui setup

2006-09-18T14:04:12Z

These kinds of errors are always due to corrupt ISO's or corrupt CDs or DVDs, I'm afraid... Please retry with a different CD-RW or DVD-RW than the one you're currently using.

Re: [NEEDS REPLY] Fatal error during gui setup

2006-09-17T23:51:27Z

hi
just did a test setup on a rig where I connected two sata hard disks (in raid1) to a ICH7GR controller which requires iastor.

it is not a DELL, and I have a P-ATA DVDRW in there.
I wonder wether this is because your machine uses S-ATA for the optical drives.

I used method 2
all packs
and had no problem.

in the past, I sometimes saw ATAPI drive letters change.
you could put a copy of the slipstreamed DVD in both drives?

[NEEDS REPLY] Fatal error during gui setup

2006-09-16T14:39:09Z

I am trying to install Windows XP on a Dell Dimension 9200 which has the Intel iastor.sys driver. I download some driverpacks and with driverbase slipstreamed them in so that now it can see the sata drive during textmode.

Once it boots into the gui setup and is at installing windows section after a copy minutes I can a Fatal Error.

Error:
Installation Failed: D:\i386\asms. Error Message: The request could not be performed because of an I/O error.

I have tried several CD-Rs and two differenet XP/SP2 iso images. I get the same error.

Any suggestions? The Dell has two DVD drives connected via SATA cables (1 DVD, 1 DVD-RW) and a SATA 250 GB hard drive. Without doing this integration I couldn't get this far, using a boot disk method would failed because it couldn't find iastor.sys for some reason.

Thanks.