DriverPacks.net Forum - Integrate drivers to boot.wim in a Windows 7 x86/x64 AIO

Re: Integrate drivers to boot.wim in a Windows 7 x86/x64 AIO

null@example.com (diabolo131313) — Sun, 06 Jan 2013 00:49:14 +0000

Thanks all you guys for your guidance

null@example.com (OverFlow) — Sat, 05 Jan 2013 05:15:48 +0000

it is possible to remove the existing drivers (non native drivers previously added by dism)

you could then add all new drivers... and have no conflicts.

it is also possible to pick and choose ... but this sounds tedious.

check the docs tab on the / our home page... i posted some notes a while back that help with adding / deleting drivers

null@example.com (diabolo131313) — Sat, 05 Jan 2013 01:36:58 +0000

So I could infer from your comments is better to inject drivers in both architectures separately and make the AIO at the end, right?

null@example.com (mr_smartepants) — Fri, 04 Jan 2013 20:43:41 +0000

DISM is very resilient when it comes to drivers.
Try it, the worst you could do is waste your time.

null@example.com (Damnation) — Fri, 04 Jan 2013 19:38:02 +0000

I'm not sure, I think you would run into driver conflicts.

null@example.com (diabolo131313) — Fri, 04 Jan 2013 18:26:05 +0000

Is it possible to integrate mass storage and chipset drivers to boot.wim in an already done Windows 7 AIO that has both x86 and x64 architectures?