DriverPacks.net Forum - [CLSD] Insufficent memory for iaStorS.SY_.

Re: [CLSD] Insufficent memory for iaStorS.SY_.

2012-06-10T08:36:49Z

...no response means no support...

Re: [CLSD] Insufficent memory for iaStorS.SY_.

2012-04-11T05:30:29Z

Well that's odd. That HWID isn't supported. It appears that you have your controller in "legacy" mode. Can you switch it to AHCI mode and retry?

Re: [CLSD] Insufficent memory for iaStorS.SY_.

2012-04-09T19:07:42Z

Posted below for the physical system. I've actually been testing in VirtualBox for the most part (only did one actual CD and tried it on my system). What do you think it is? To me it seems like a possible memory leak with the pause and error message it gives.

PCI\VEN_8086&DEV_3A20&SUBSYS_72708086&REV_00
PCI\VEN_8086&DEV_3A20&SUBSYS_72708086
PCI\VEN_8086&DEV_3A20&CC_01018F
PCI\VEN_8086&DEV_3A20&CC_0101

Re: [CLSD] Insufficent memory for iaStorS.SY_.

2012-04-09T18:57:17Z

Hmmm. I think I know what's causing this. Can you post your HWIDs?

[CLSD] Insufficent memory for iaStorS.SY_.

2012-04-09T18:25:29Z

I'm trying to get a BartPE 3.1.10a generated Sever 2k3 live CD to boot with SATA support so I downloaded and successfully slip streamed it with Mass Storage 12.03. Everything regarding the generation works fine until I boot it. I get this error:

Insufficent memory for iaStorS.SY_.

This is on a black screen. I press enter and it wants to reboot (no gui).

Any thoughts or suggestions? I tried increasing the RAM on the machine to 3 GB, and increasing the size of the BartPE ramdisk to 1 GB but the error still persist.

Thank you in advance for any help.