When XP runs form network the error cames long before "Press F6 for mass storage..."

usb nic support with native windows ... "not"

I have make the changes and modefied the presetup.cmd, but installation will not work.

I became the same error like before:

http://support.microsoft.com/kb/247983/en

You said: you just need to make sure the OEM folder is copied to $win_nt$.~ls (it should be automagically copied)

but how to make it possible if you have an SATA-Controller that's not supported before the driver in textmode loaded?

Regards
Jackson

finisher .. your choice
KTD off
QSC on

At the past a used the DP's to integrate all drivers without (WLAN, Graphics C and 3party) in my XP-DVD
with method 1 with massstorage text mode ON and KTD OFF. That's works fine for me...

So what i have to change to make the RIS-Install possible?

Change slipstream method from method 1 to method 2?
Method to start the finisher: GUIrunOnce ?
Change KTD from OFF to ?
QSC enable?

Regards
Jackson

presetup is added when you use DriverPacks BASE to slipstream DriverPacks into your source

Where can i get the file?

Will the presetup.cmd starts automaticly by installation?

Regards
Jackson

another option is to make sure to add the full set of DriverPacks is copied and installed with your pxe image.

see here for an idea  http://forum.driverpacks.net/viewtopic.php?id=4808

you just need to make sure the OEM folder is copied to $win_nt$.~ls (it should be automagically copied)

I try to make my XP installations over networkboot (PXE), because the booting is much
faster like from CD/DVD...

The XP setup starts fine an then i becam this error:

http://support.microsoft.com/kb/247983/en

The networkcard is not supportet form windows, same problem as many mass storage drivers when
not included in the textmode...

http://support.microsoft.com/kb/246184/EN-US/

How can i bind the lan drivers in the textmode automaticly like mass storage?

Regards
Jackson