or are there other ideas somewhere else I need to read about :-)
]]>If cdob says it will work i would take that bet...
]]>But then, I never really actually use recovery console (I make frequent backups).
Wish I had more time...
Me too.
@McStarfighter
A half manual way, rough idea, not tested:
Create a new driverpack massstorage installation CD.
Backup \cmdcons\txtsetup.sif.
Copy driverpack massstorage txtsetup.sif to \cmdcons\txtsetup.sif.
Open device manager. Remember massstorage controller HardwareID.
Edit \cmdcons\txtsetup.sif:
compare HardwareID at [HardwareIdsDatabase] section
remember used drivers
goto [SCSI.LOAD] section, remove all, but keep required drivers.
Compare [BusExtenders.Load] section too.
Copy new massstorage controller driver to \cmdcons\.
Good luck.
]]>@Galapo
Boot regular windows or PE: add driver and settings to \cmdcons.
Hmmm, never thought of doing that. But then, I never really actually use recovery console (I make frequent backups).
Wish I had more time...
Regards,
Galapo.
McStarfighter wrote:You can install the recovery console to HD with the command "...\I386\winnt32.exe" /CMDCONS /UNATTENDED.
OfflineSysprep and fix_hdc could be enhanced: add required drivers only from a offline system.
Hi cdob,
Not quite sure what you mean: did you intend "from an offline system" or "to an offline system"?
Thanks,
Galapo.
You can install the recovery console to HD with the command "...\I386\winnt32.exe" /CMDCONS /UNATTENDED.
Yes, that's it.
And if you use proper source files, then there are AHCI drivers at Recocery Console too.
Use a installation CD with integrated MassStorage Driverpacks.
My problem is that the recovery console on the HD has the "F6 problem".
Which "F6 problem" do you have? Insert a proper floppy and press F6.
And so I want to know how I can "modify" the installed recovery console for MassStorge support like in textmode.
One massstorage solution does edit txtsetup.sif and add driver files. So does driverpacks and Bart.
A description http://www.msfn.org/board/Add-slipstrea … 77999.html
Which hardware do you use?
@Galapo
OfflineSysprep and fix_hdc could be enhanced: add required drivers only from a offline system.
To get sata drivers into the project, you need to add my DriverPacks-Build_MassStorageDrivers script: http://galapo.boot-land.net/scripts/dri … ers.script
Outputted ISO has Recovery Console with DriverPacks mass storage drivers integrated.
Regards,
Galapo.
you said "but because of my SATA HD's I can't boot into it"
I naturally assumed your boot tracks were bad???
it now seems to me you are trying to create a recovery partition of your own?
is that correct?
or if you use the UBCD4Win cd you may be able to repair the boot tracks and boot.ini
or you may find lilo and have to fix that.
]]>