Is this still an issue for you? I had the same issue, but it was resolved because of a 'removed generic driver'. Please let me know as I may be able to assist you. 
Check out my thread if you want some reading to do:
]]>Is this still an issue for you? I had the same issue, but it was resolved because of a 'removed generic driver'. Please let me know as I may be able to assist you.
Check out my thread if you want some reading to do:
]]>First, sorry for the long delay in coming back to you but I didn't have access to this laptop again until today.
I tried it without resealing the image with sysprep and simply imaging the completed setup and restoring it back to the laptop and I get the exact same error on the same device : Code 10 Can not start.
Sigmatel High Definition Audio CODEC
DriverDate : 06/05/2007
Version : 5.10.5511.0
If you need me to do any test, please let me know.
Thanks,
]]>however i think you have answered my question about method already.
and we can probably proceed in the correct direction based on your input.
I'm not using RIS.
I am installing on a virtual machine and then imaging this VM after an unattended install of XP + several programs) with Acronis and restoring back.
I am using SysPrep though, but I don't use entries in sysprep files for drivers : I let the DevicePath entry in registry do its job which would be more or less the same than without SysPrep ?
If you want, I'll try to use without SysPrep (restoring an image right after the unattended setup has ended before having resealed the VM).
I asked you to try it with normal driverpack integration to prove or disprove this theory since you have the hardware to do it.
You politely declined ... no i take that back it was not polite.
"no idea about 'normal' method as have no reason to use it."
I gave you a valid reason - so we might be able to help you -
even though this is not a supported method I was still going to assist you.
Seems like the best reason there is
help us to help you..
]]>Does this issue occour if the DriverPacks are installed normaly from a CD / DVD?
PS you accidentally put this in the wrong forum (since RIS sysprep is not supported - technicaly) software is where most of the ris stuff is and "Other" is the correct place.
]]>have used latest (dev/test) sounds packs and is still getting a yellow exclam 'This device cannot start. (Code 10)' as have always had.
The driver versions its using is 5.10.5511.0
HDAUDIO\FUNC01&VEN_8384&DEV_7690&SUBYS_10280201&REV_1022\4&3474892&0&0001
KB888111 is installed, thi is same issue for any mahcine using Sigmatel audio.
In control panel is an icon 'IDT Audio Control Panel' and clicking this gives error
'IDT Audio driver is inaccesable.
Please make sure it is installed and enabled'
[I am using sysprep method]
]]>